Alarms
ADM003GVAE1005 249
Alarms
Note! Leak Detection alarms are
only functional for Real-Time leak
analysis
The leak rate alarm is used to trigger real-time alarms associated with calculated
real-time leak rate. The leak data alarm is used to trigger a real-time alarm when
there is not enough quiet time in the tank to produce a valid Leak Test Report.
Tank Data dialog -
Alarm page
Alarms Description
Leak Rate Allows an Enable/Disable State and allows the entry of High
absolute values. The Leak Rate alarm is triggered if the
absolute values of the Leak Rate exceed the defined High
absolute limits
Leak Data Allows an Enable/Disable State. This alarm, when enabled,
will alert every day at 12:00 AM to notify the operator that
there is not enough valid data or quiet time data from the
configured tank to produce a valid Leak Test Report
To Next Page
Loading...