ATD2 10511 - After Updating the Database; Rename Your Database as the Local Machine Name; Checking Your System; Rebuild Graphics and Reports

Error messages and troubleshooting
ADM003GVAE1005 261
After Updating the Database
Rename Your Database as the Local Machine Name
If necessary, you can start FMSystemManager and run FMSystemConfig to
rename the database to the local machine.
Checking Your System
After you upgrade your database system to 6.0 with the utility, open Configuration
and verify that your groups, users, system permissions, and tag permissions are
still working properly. Since some of the security rights definitions have changed,
they may not match perfectly.
The update utility created a back-up copy of the old files that were changed.
These files are located in the “Copy of FMProject” directory. This is not a complete
back-up of your entire database, and includes only the files that were changed in
the upgrade.
Rebuild Graphics and Reports
You will have to rebuild the following:
•Symbols
•Graphics
• Detail Mode Symbols
• Detail Mode Graphics
• Rebuild Reports
Back up FMProject
After doing all this you should and back up your new FMProject.