ATD2 10511 - Setting Subsystem Run Modes; System Selection

Setting subsystem run modes
ADM003GVAE1005 51
Setting subsystem run modes
Note! Setting subsystem run
modes must be done after a new
installation. The system defaults
everything to shutdown and none.
This section lets you start and stop the different FuelsManager services. It also
lets you set which of these services should automatically start when
FMSystemManager starts.
System Selection
Note! The Select FuelsManager
System dialog only displays active
FuelsManager installations. If your
system is not listed, make sure the
appropriate ‘manager’ is active.
FuelsManager Configuration can be used to configure the local FuelsManager
application or a remote FuelsManager on the LAN or WAN. Nearly all
FuelsManager Configuration dialogs contain a System Name field and a Select or
Browse button that allows you to pick which FuelsManager system is to be
configured. In this case, the user can select a different server on the network by
clicking Select, which opens the Select FuelsManager System dialog. Then
choose a different system and click Select.
Select FuelsManager
System dialog box