Edit Tank Data
ADM003GVAE1005 247
Edit Tank Data
All leak relevant data must be configured in the Edit Tank Point Data dialog for
each tank when a leak analysis is performed. The minimum leak rate value,
maximum leak rate value and leak rate units for the tank are configured on the
General page of the dialog.
Note! The fields described in this
section for the Edit Tank Data
dialog only apply to those related
to Leak Detection. For descriptions
of other fields on the Edit Tank
Data dialog, refer to the Databases
section of this manual.
Edit Tank Data dialog -
General page
Leak Detection Variables Assignment Options
Leak Rate Minimum values, Maximum values and Engineering Units
To Next Page
Loading...