Automated Data Output Configuration Dialog
ADM003GVAE1005 267
Default This button deletes all variables from the “Tank
Variables to be logged” list box, and then adds the
Automated Data Output default set of variables to that
list box. This default list is generally accepted as the
most commonly used set of variables, and includes
the following:
• System Name
•Point Tag
• System Date and Time
•Product Code
• Level
• Temperature
• Standard Density
• Gross Volume
• Net Standard Volume
• Available Volume (Net)
• Remaining Volume (Net)
• Flow Rate
Precision The precision of the data in the output files can be
entered here. The Precision field defines the number
of decimal places you want in the values logged. If
you enter 0, no decimal places will be logged
Trigger Point, Trigger
Value
A FuelsManager point can be entered and you can
set the trigger value. The Trigger Point that you use
must be an Input point, and must be set to a Manual
Data Source. When the trigger point equals the
trigger value, Automated Data Output will write the
snapshot file. This method can be used to manually
initiate the log process when needed, or to cause the
log process to initiate automatically whenever a
particular event takes place
Reset Value After the Trigger Value is reached and a snapshot file
is created, Automated Data Output sets the Trigger
Point value to the Reset Value
Trigger Time 1, Trigger
Time 2
Two distinct trigger times can set so that the log
process runs once or twice every 24 hours. To set a
trigger time, check the box to the left of the time field
you want to set, and then enter the trigger time into
the appropriate field
To Next Page
Loading...