Variable Value
Pair2Length Indicates the length of the second pair in the
cable, in meters, measured by the TDR.
Pair3Status Indicates the status of the third pair in the
cable. Values include:
•
1—pairFail
• 2—pairNormal
• 3—pairOpen
• 4—pairShorted
• 5—pairNotApplicable
• 6—pairNotTested
• 7—pairForce
• 8—pinShort
Pair3Length Indicates the length of the third pair in the
cable, in meters, measured by the TDR.
Pair4Status Indicates the status of the fourth pair in the
cable. Values include:
• 1—pairFail
• 2—pairNormal
• 3—pairOpen
• 4—pairShorted
• 5—pairNotApplicable
• 6—pairNotTested
• 7—pairForce
• 8—pinShort
Pair4Length Indicates the length of the third pair in the
cable, in meters, measured by the TDR.
CableLength Indicates the length of cable, in meters,
based on average electrical length of 4 pairs.
This measurement can be performed
whether or not network traffic is present on
the cable.
Pair1Polarity Indicates the polarity of the first pair in the
cable. This capability is available only when
the cable gigabit link is up, regardless of
traffic activity. Values include:
Initiating a cable diagnostic test using EDM
Configuration — System April 2011 269
To Next Page
Loading...
