ELECTRICAL INSTALLATION
86
AV7000 LINEAR CAMERA
6. Carefully push the USB and VGA cables into the camera housing above the circuit
board as shown below.
7. Carefully position the VGA / USB Interface Panel Kit cover and tighten the four
screws at its corners.
8. Attach the monitor to the VGA port and the combination keyboard/mouse to the
USB port (MONIT
OR/KEYBRD/BRKT/USB HUB KIT, 93ACC0126).
9. Reapply power to the AV7000 Camera.
NOTE: When the camera is powered on, the monitor comes on after several
seconds and displays an image of the AV7000 camera system. To access a
browser (Firefox), right click with the mouse on the monitor window. A drop-down
list appears. Select Firefox to open the browser to the e-Genius Log On window.
To Next Page
Loading...
Need help?
General
