REPLACING AV7000 WITH A FAILED MEMORY CARD
PRODUCT REFERENCE GUIDE
429
6. Press the card eject button and remove the memory card from the camera.
7. Place the replacement camera on a flat surface, and remove the back access
panel.
8. Insert the memory card firmly into the card slot in the replacement camera.
9. Reattach the back access panels and secur
e it with the retaining screws.
10. Attach the replacement camera assembly to the illumination. Lift the camera into
place
, inserting the lens through the lens hole and the Locator Pin into the Locator
Pin Hole.
11. Screw the mounting bolts in place to secure the camera
12. Reattach the cables to the camera in their original locations.
13. Apply power to the AV7000 Camera.
REPLACING AV7000 WITH A FAILED MEMORY CARD
Sometimes a failed memory card can cause a Camera Assembly to fail. In this case
replacing the camera assembly and transferring its memory card to a replacement unit
will not resolve the problem. In these situations, you need to replace an AV7000 Camera
with a failed Memory Card.
This procedure works for both a controller and a client in a tunnel/array. A standalone
unit will
be handled differently.
1. Disconnect the power source from the camera.
2. Disconnect all the cables except for the fan cable from the camera.
To Next Page
Loading...
Need help?
General
