E-GENIUS
90
AV7000 LINEAR CAMERA
If the password is not valid, the application displays a results box with the message,
“Incorrect Password.” Click OK to return to the Log On window and enter the correct
user name and password. If you don’t know the password, contact your system man
-
ager.
Changing Your PC’s IP Address:
1. From the desktop click the Windows or Start button, and enter Control Panel.
2. Select Net
work and Sharing Center, then click Change adapter settings or select
the Local Area Connection you wish to change.
3. Right-click on the Local Area or Ethernet Connection you wish to change, and
sel
ect Properties.
4. Select the Networking tab. Under This connection uses the following items, click
Internet Protocol Version 4 (TCP/IPv4), and then click Properties.
5. Select Use the
following IP address. In the IP address field, type the first 3 octets
of the IP address of the unit.
6. For the last octet, type a number that differs from the last octet in the unit’s IP
add
ress. The actual number used is not important as long as it does not match
that of the unit.
For Example:
If the camera’s IP Address is 192.168.3.10, set your PC’s IP Address to
192.168.3.11.
7. In the Subnet mask field, type 255.255.255.0
8. Click Ok
ay to save your changes.
WARNING: The user ID and password shown above provide full setup rights
to the user. If a user only needs to view system information without saving
changes, the User ID: monitor and Password: DLAmon should be used.
NOTE: Your PC may name the LAN port different than the Local Area Con-
nection. For example, “Ethernet”.
To Next Page
Loading...
Need help?
General
