PHOTOELECTRIC SENSOR CONNECTIONS TO CBX100/800
PRODUCT REFERENCE GUIDE
73
Photoelectric Sensor Connections to CBX100/800
Barcode scanning applications may use a Datalogic photoelectric sensor as a trigger
device. The photoelectric sensor is wired directly into the CBX510 terminal block.
If your application uses a trigger other than the
one specified by Datalogic, follow the
appropriate wiring diagram to assure proper wiring.
The following diagrams illustrate standard recommended wiring of the Photoelectric
Sensor to the CBX510 terminal block.
Photoelectric Sensor to CBX100 and CBX800 (NPN)
WARNING: You must use shielded interface cables with this product. To
maintain FCC compliance, the cable shield must make a 360-degree con-
nection to the shielded mating connector.
NOTE: To confirm the photoelectric sensor
is functioning properly, watch
the TRIGGER LED first in the CBX and also on the camera while the photo-
electric sensor’s beam is blocked. The Datalogic photoelectric sensor also
includes a status LED.
To Next Page
Loading...
Need help?
General
