Datalogic AV7000 User Manual

E-GENIUS
316 AV7000 LINEAR CAMERA
Default Parameters
The user shall be able to default the parameters with the express button on power up,
This procedure is as follows:
1. Press and hold Xpress button and apply power to the unit.
2. The unit will recognize the button press within 15 seconds and blink all five LEDs
thr
ee times (once per second)
3. Release the Xpress button once the LED’s start blinking
4. All 5 LEDs will turn off after 3 blinks
5. Press and release the Xpress button again within 5
seconds (all LEDs will turn on)
6. All 5 LEDs will blink 3 more times to confirm parameter defaulting will take place
7. Normal LED boot sequence will take place
8. All 5 LEDs will start blinking after the boot sequence
finishes. Blinking will con-
tinue until the parameters are defaulted
9. If you are connected to e-Genius you will notice that the RTP will report the fol-
lowing “critical” message to the web interface until the default sequence is com-
pleted: "W
aiting for Xpress Parameter Default to Complete"
10. The following error will be reported if the RTP requests an Xpress default but the
C
OMe does not know about it "Xpress parameter default requested but ignored"
NOTE: If the Xpress button is still pressed after the blink sequence ends,
the default
request will be ignored.
NOTE: Failure to press the Xpress button within 5 seconds
will result in the
default request being ignored.

Datalogic AV7000 Specifications

General

Brand	Datalogic
Model	AV7000
Category	Digital Camera
Language	English