AUTOMATED MOUNTING CALIBRATION
PRODUCT REFERENCE GUIDE
231
Calibration Target
Sample Calibration Package on Conveyor
Sample Calibration Package with Close-up of Target Position
Sometimes available box sizes will not allow for the entire target. You can trim the tar-
get to fit, however the distance from the edge of the box to the target must be as desig-
nated. The critical portions of the target are illustrated below.
NOTE: A calibration target is available for letter and A4 size paper. If printing the target,
make sure you are printing the right target on the correct size paper. Otherwise it may
appear as if your calibration is correct and complete and it will not be!
To Next Page
Loading...
Need help?
General
