FOCUSING SETUP AND CALIBRATION
370
AV7000 LINEAR CAMERA
2. Make sure the selected Baud Rate matches that of the AV7000 (AV7000 uses the
main port, RS485 (RS422), at 115200).
3. Under Message Format, select Camera Focus from the Focus messages for Data-
logic cameras dr
op-down list.
4. Select the Model of
camera for which you are focusing.
5. Enter the F
ocus Transmit Point. This is the distance the DM3610 waits until after
the AV7000 scan line has read, to transmit the message. This value correlates to a
value in the AV7000 settings. Default is 8 inches.
6. Enter the F
ocus Transmit Interval. This is the amount of milliseconds between
data transmissions. It defines the frequency of the data transmissions from the
DM3610(s).
7. Click Upda
te to save the changes.
8. The distance between the far working distances of the cameras is considered the
“Con
veyor Width” and must also be entered in the Conveyor Width field in
AV7000 Global Settings | Operating Mode.
To Next Page
Loading...
Need help?
General
