Chapter 21: Fades and Crossfades 479
2 Nudge the region by pressing Plus (+) or Mi-
nus (–) on the numeric keypad.
Moving Regions Adjacent to Crossfades
When you move either of the regions that con-
tributes to a crossfade, the regions separate. The
status of the fade depends on the Preserve Fades
when Editing preference (in the Editing Prefer-
ences page).
To separate crossfaded regions and retain the
corresponding fades:
1 Choose Setup > Preferences and click the Ed-
iting tab.
2 Select Preserve Fades when Editing.
3 Click OK to close the Preferences dialog.
4 Use the Time Grabber or Separation Grabber
tool to select one of the contributing regions to
a crossfade.
5 Drag the selected region with the Grabber.
To separate crossfaded regions and remove the
fade:
1 Choose Setup > Preferences and click the Ed-
iting tab.
2 Deselect Preserve Fades when Editing.
3 Click OK to close the Preferences dialog.
4 Use the Time Grabber or Separation Grabber
tool to select one of the contributing regions to
a crossfade.
5 Drag the selected region with the Grabber.
Nudging Regions Adjacent to
Crossfades
When you nudge either of the regions that con-
tributes to a crossfade, the fade stretches to pre-
serve the relative position of the crossfade start
and end points. The amount of stretch depends
on the amount of overlap between the contrib-
uting regions.
If you nudge a region beyond the boundary of
available audio for the crossfade, the fade is re-
moved.
Nudging a region without its fade
Selecting a region with a crossfade
Separating regions while preserving fades
Selecting a region with a crossfade
Separating regions while removing fades
To Next Page
Loading...
Need help?
General
