Pro Tools Reference Guide514
4 Click Apply to insert the new meter event. The
new meter event is inserted and appears in the
Meter ruler.
Each meter event has a small yellow triangle
next to it that indicates its location. These trian-
gles can be selected for copying and pasting, and
they can be double-clicked to edit the meter
event.
Editing Meter Events
Existing meter events can be edited, deleted,
and copied and pasted.
To edit a meter event:
1 In the Meter ruler, double-click the meter
event.
2 In the Meter Change dialog, enter a new Loca-
tion or Meter for the event.
3 Click OK.
To delete a meter event:
■ While pressing Alt (Windows) or Option
(Mac), move the cursor over the meter event
(where the cursor changes to the Grabber with a
“–”) and click to remove it.
To copy and paste several meter events:
1 If you want to constrain the selection to the
current Grid value, set the Edit mode to Grid.
2 Drag in the Meter ruler to select the range that
includes the meter events.
If the beginning of the selection includes a
meter event, press Control (Windows) or Com-
mand (Mac) so the Selector tool appears.
3 Choose Edit > Copy.
4 Click in the Meter ruler at the point where you
want to paste the meter events.
5 Choose Edit > Paste. The contents of the Clip-
board are pasted from the insertion point, re-
placing any existing meter events.
To extend an Edit selection in a track to the Meter
ruler:
1 Using the Selector tool or any Time Grabber
tool, select a track range.
2 Shift-click in the Meter ruler.
Shift-click again in the Meter ruler to remove it
from the selection.
To select all meter events:
■ Double-click with the Selector tool in the
Meter ruler.
Inserted meter event
Meter events selected
Press Alt (Windows) or Option (Mac) while
dragging to select across all Conductor
tracks.
To Next Page
Loading...
Need help?
General
