Chapter 23: Conductor Tracks and Memory Locations 529
Recalling Memory Locations
Memory Locations can be recalled from the
Memory Locations window and from the nu-
meric keypad. In addition, Marker Memory Se-
lections can be recalled by clicking them in the
Markers ruler.
To recall a Memory Location:
1 If the Memory Locations window is not al-
ready open, choose Window > Memory Loca-
tions to display it.
2 If recalling a Selection Memory Location that
will define a record or play range, make sure to
select Options > Link Timeline and Edit Selec-
tion.
3 Do one of the following:
• In the Memory Locations window, click the
Memory Location to recall it.
• With the Numeric Keypad mode set to
Classic, press the Memory Location num-
ber followed by Period (.).
• With the Numeric Keypad mode set to
Transport or Shuttle, press Period (.), the
Memory Location number, and Period (.)
again.
To recall a Marker from the Markers ruler:
1 If the Markers ruler is not displayed, select
View > Rulers > Markers.
2 Click the Marker. The playback cursor locates
to the Marker and any General Properties stored
with the Marker are recalled.
Editing Memory Locations
Memory Locations can be renamed, edited, de-
leted, and copied and pasted.
To rename a Memory Location:
1 Do one of the following:
• In the Memory Locations window, double-
click the Memory Location you want to re-
name.
– or –
• If renaming a Marker Memory Location,
double-click the Marker in the Markers
ruler.
2 Enter the new name for the Memory Location,
and click OK.
To redefine the General Properties stored with a
Memory Location:
1 Make changes to the session’s zoom settings,
pre- and post-roll times, Show/Hide status of
tracks, Track Heights, or Group Enables.
2 Do one of the following:
• In the Memory Locations window, Right-
click (Windows) or Control-click (Mac) the
Memory Location you want to redefine.
– or –
• If changing a Marker Memory Location,
Right-click (Windows) or Control-click
(Mac) the Marker in the Markers ruler.
3 In the Memory Location dialog, select the
General Properties you want to save with the
Memory Location.
4 Enter a new name for the Memory Location, if
desired, and click OK.
When recalling a Memory Location from
the numeric keypad, the Memory Locations
window does not need to be open.
Even if the Markers ruler is not displayed,
Markers can be recalled from the Memory Lo-
cations window, or from the numeric keypad.
To Next Page
Loading...
Need help?
General
