EnerSys Alpha Cordex CXC HP - DC Source Systems; Create a DC Source System

Cordex®CXCHPControllerSoftwareManual|10-Distributionsystems
Withinthedistributionsystem,thiswizardisonlyavailableforuserdefinedsubsystems.Youcanlaunch
thiswizardfromanyofthetablesinsubsystemsthatshowshunts.Thefollowingexampleshowshowto
configureasubsystemforaCordex®CXPS-Ccentralizedpowersystem.
To create a Cordex® CXPS-C centralized distribution subsystem:
1. FollowthestepsdetailedintheCreating a User Defined Subsystem section,creatingsixpanels,
withfourbreakersperpanel,andoneshuntperbreaker.
2. EnsurethatfourCordex®CXCHP6iADIOperipheralsareacquiredandnamedasperthe
schematic(#1-#4).
3. GotoSystems > Distribution System > Subsystems > Subsystem > Shunts,andselectMap
Shunts to ADIO Inputs.
4. OntheShunt Mapping Type step,ensurethemappingtypeisselectedasMap Shunts in Bulk
andselectNext.
5. LeavethefirstpanelselectedintheSelect Starting Panel step,andselectNext.
6. OntheADIO To Shunt Configuration step,settheADIOConfigurationasADIOs Wired
Sequentially andselectNext.
7. SelectADIO#1fromthedropdownlist,andthenselectAdd Selected ADIO to List.Youwillsee
thelistbelowupdatewiththeADIOmoduleyoujustselected.
8. RepeatforADIOmodules#2to#4,andthenselectNext.
9. TheReview stepdetailswhichinputsaremappedtowhichshunts.Reviewtoensureitmatches
thewiringschematic.
10. SelectNext,andthe24inputsofthefourCordex®CXCHP6i-ADIOperipheralswillnowbe
mappedtothe24shuntsintheuserdefinedsubsystem.
Page 134 0350058-J0 Rev AL