TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 393
Converting a tower model to a rack model
Removing the accessible drive cage
Ê Remove the front panel module as described in section "Removing the front
panel module" on page 329.
Ê If applicable, remove all accessible drives as described in section
"Removing an accessible drive" on page 286.
Ê If applicable, remove an HDD extension box as described in section
"Removing an HDD extension box" on page 179.
Figure 299: Detaching the accessible drive cage (A)
Ê Remove two screws from the bottom side of the server as shown.
Ê Bring the server back to its horizontal position.
I At least two people are needed to turn over a fully equipped server.
Remove hard disk drives and power supply modules in order to
facilitate the task.