HP DesignJet Z2100

Service Tests and Utilities
3-26 Designjet Z Series — Service Manual
32 Press OK to the test the Formatter. If you do not wish to test the Formatter use
the Arrow keys to select NO and press OK.
33 The Formatter Communications test starts and the front Panel displays the
following messages:
 Starting Micci2Bus.
 Starting Micci2BusProxy.
 Checking Communications.
34 The Front Panel then displays Formatter Communications test results and
prompts you to press any key to continue.
35 Press any key to continue.
36 The Front Panel then prompts you to check the Plotter Information.
37 Press OK to the check the Plotter Information. If you do not wish to test the
Plotter Information use the Arrow keys to select NO and press OK.
38 The Plotter information test starts and the Front Panel displays the following
messages:
 Starting Nvm
 Accessing Nvm.
 Getting Plotter info.
39 The Front Panel then displays the Plotter Information results and prompts you
to press any key to finish.
40 Press any key to finish.