HP DesignJet Z2100

Service Tests and Utilities
3-30 Designjet Z Series — Service Manual
 Setting LS low intensity.
For each color LED: Blue, Green, Red, and Amber
 Setting LS max intensity.
For each color LED: Blue, Green, Red, and Amber
 Checking Tolerance.
 Deactivating LS.
 Starting NvmLineSensor.
 Initializing NvmLineSensor.
 Getting LS Serial Number.
 Reading LS Nvm.
 Writing new LS Nvm.
 Checking LS Serial Number.
 Restoring LS Serial Number.
 Starting Service Station.
 Starting Scan Axis.
 Moving SVS out of sax.
 Homing Scan Axis.
 Moving Carriage out of SVS.
 Homing Service Station.
 Starting Servicing Services.
 Capping Service Station.
 Uncapping Service.
 Moving to Pen position.
 Reading Pen presence.
 Starting ColorSensing.
 Reading esp status.
22 The Front Panel then prompts you to enable the Color Sensor ESP
(spectrophotometer).
23 Press OK to the enable the Color Sensor ESP (spectrophotometer). If you do
not wish to enable the Color Sensor ESP (spectrophotometer) use the Arrow
keys to select NO and press OK.
24 The Color Sensor ESP (spectrophotometer) enable test starts and the front
Panel displays the following messages:
 Starting ColorSensor.
 Starting ColorSensing.
 Reading Color Sensor ESP (spectrophotometer) status.
 Enabling Color Sensor ESP (spectrophotometer).