Designjet Z Series — Service Manual 6-9
Removal and Installation - Service Calibration Guide to Removal and Installation
Service Station Spittoon 1 2
Primer Assembly 1 2
Left Ink Supply Station 1
Right Ink Supply Station 1
Carriage Cover 3 1 2
Carriage Latch 3 1 2
Carriage PCA 3 1 2
PrintMech PCA 1
Front Panel 1
Power Supply Unit (PSU) 1
Main PCA 1
Ink Supply Tubes 1 2 3
Media Advance Drive 1 3 2
Encoder Disk 1 3 2
Encoder Sensor 1 3 2
Media Advance Roller 1 3 4 2
Carriage Assembly 2 5 1 4 3 6
PRS Test
Scan Axis Test
Cutter test
Star Wheel Lifter test
2. Paper Drive
3. Electronics Module
4. Carriage Assembly
5. Sensors
Color Sensor ESP (spectrophotometer) Calibration
7. Ink Delivery System (IDS)
8. Service Station
Paper Advance Calibration
Drop Detector Calibration
Line Sensor Calibration
4. Reset Life Counters (after replacement only)
To Next Page
Loading...