6-10 Designjet Z Series — Service Manual
Removal and Installation
Belt Tensioner 2 1 4 3
Belt Assembly 2 1 4 3 5
Scan-Axis Motor 2 1 4 3 5
Trailing Cable 2 1 4 3 5
Carriage Rear Bushing 2 5 1 4 3
Line Sensor 3 2 1
Window Position Sensor 2 1
Out of Paper Sensor 1
Right Roll Guide 1
Left Roll Guide 1
Clean Out Assembly 1
Pen to Paper Space (PPS)
Solenoid
1
Encoder Strip 1
Starwheel Assembly 1
Starwheel Motor 1 2
Left Starwheel Lifter 1 2
Right Starwheel Lifter
PRS Test
Scan Axis Test
Cutter test
Star Wheel Lifter test
2. Paper Drive
3. Electronics Module
4. Carriage Assembly
5. Sensors
Color Sensor ESP (spectrophotometer) Calibration
7. Ink Delivery System (IDS)
8. Service Station
Paper Advance Calibration
Drop Detector Calibration
Line Sensor Calibration
4. Reset Life Counters (after replacement only)
To Next Page
Loading...