6-112 Designjet Z Series — Service Manual
Removal and Installation
10. Slide the new 2 Levels Wedge to the left
position.
11 . Reinstall the outside Slider Bushing Guide.
12. Replace the PRS Torsion Spring, taking
care that it holds the Slider Bushing Guide
properly.
13. Reinstall the Carriage Assembly and
Trailing Cable, (Refer to page
5-100).
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations for the Carriage Assembly. To find which
calibrations you must perform, Refer to page 6-8,
Service Calibration Guide
to Removal and Installation
.
The Extra High PRS Wedge service part includes extra PRS Torsion Springs
(Q5669-00269), Slider Bushing Guides (Q5669-40502) and 2 Level Wedges
(C7769-40065) in case these parts are damaged during installation.
To Next Page
Loading...