6-204 Designjet Z Series — Service Manual
Removal and Installation
10. SNAP IT INTO PLACE: Finally, press down
on the center to snap the Pinch Roller metal
shaft into place. When the Pinch Roller
metal shaft is correctly snapped into place,
you will hear a "click".
11 . When the assembly operation is finished,
the Pinch Rollers should be aligned with the
Pinchwheel Assembly as shown. The rollers
should also turn freely, without friction.
12. If the rollers are NOT correctly aligned or
do NOT turn freely, remove the new Pinch
Roller and go back to step 7. Make sure
the new Pinch Roller was not damaged in
any way.
The Rubber Pinchwheel Kit includes 4 Pinchwheel Assemblies in case these
parts are damaged during installation.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
Refer to page 6-8,
Service Calibration Guide to Removal and Installation
.
To Next Page
Loading...