Status Reporting 41
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1563
Example The following example uses the resource session object's ReadSTB method to read
the contents of the oscilloscope's Status Byte Register.
varQueryResult = myScope.IO.ReadSTB
MsgBox "Status Byte Register, Serial Poll: 0x" + Hex(varQueryResult)
See Also • "*STB (Read Status Byte)" on page 250
Use Serial Polling to Read Status Byte Register. Serial polling is the preferred method to read
the contents of the Status Byte Register because it resets bit 6 and allows the next enabled
event that occurs to generate a new SRQ interrupt.
To Next Page
Loading...
Need help?
General
