2JZ/2JX/2JV/2H7-1
1-3-5
Developing
U147 Setting for toner applying operation
Transition Time
Set Operation Mode
Upper Limit
Sleeve Cleaning Interval
Set Drum Cleaning Mode
Set Minimum Value
70
MODE1/1.0/1.0/1.0/1.0
5.0
60
MODE1
10/20
U148 Setting drum refresh mode ON
U155 Displaying the toner sensor output -
U156 Setting the toner replenishment level
Supply Level
Empty Level
502/502/502/502/502
101/101/101/101/101
U157 Checking the developing drive time -
U158 Checking the developing count -
Fuser U161 Setting the fuser control temperature
Ready Temp. 153
*1
160
*1
Stable (Driving) 160
*1
165
*1
Stable (Stop) 160
*1
165
*1
Temp. Print Full 16 0
*1
165
*1
Shift Print Dup 0
*1
-5
*1
P. Rol l er Te m p . 130
*1
140
*1
U163 Resetting the fuser problem data -
U167 Checking/clearing the fuser count -
U199 Displaying fuser heater temperature -
Operation
panel and
support
equipment
U200 Turning all LEDs on -
U201 Initializing the touch panel -
U202 Setting the KMAS host monitoring system -
U203 Operating the DP separately 0
*1
U204 Setting the presence or absence of a key card or
key counter
OFF
*1
U206 Setting the presence or absence of the coin vender -
U207 Checking the operation panel keys -
U208 Setting the paper size for the paper feeder Letter (Inch)/A4 (Metric)
*1
U220 Setting the trial functions -
U221 Setting the USB host lock function OFF
*1
U223 Operation panel lock Unlock
*1
U224 Panel sheet extension -
U234 Setting punch destination AUTO
U237 Setting finisher stack quantity 0/0
*1
U240 Checking the operation of the finisher -
U241 Checking the operation of the switches of the fin-
isher
-
U243 Checking the operation of the DP motors -
U244 Checking the DP switches -
U245 Checking messages -
Section
Item
No.
Content of maintenance item
Initial setting*
25/25,30/30 ppm 40/40 ppm 50/40 ppm
*Initial setting for executing U020, *1: The item initialized for executing U021
To Next Page
Loading...
