Sensor (ADF media exit) late jam service check
Action Yes No
Step 1
a Check if the original document is free of paper clips and staples
as well as creases, tears, holes, or excessive wear.
b If the original document is damaged, replace it, and then
perform an ADF test.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Check the ADF rolls for wear, and if necessary, replace the ADF
rolls. Go to
“ADF feed/pick roll assembly removal” on page 534
or
“ADF separator torque limiter assembly removal” on
page 536.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Check the media path for contaminates. Make sure that the media
path is free of excess media dust and foreign objects such as paper
clips and staples.
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
Check the sensor (ADF media exit) for proper operation.
a Enter the Diagnostics menu.
b Select SCANNER TESTS > Sensor Tests.
c Observe the line, “sensor (ADF media exit).”
Does the display on the operator panel change every time the
sensing area of the sensor is interrupted or blocked?
Go to step 6. Go to step 5.
Step 5
a Check the sensor (ADF media exit) for proper connection.
b Replace the connection, if necessary.
Does the problem remain?
Go to step 6. The problem is
solved.
Step 6
Replace the sensor (ADF media exit). Go to
“Sensor (standard exit
bin) actuator assembly removal” on page 384 or “Sensor (ADF
media exit) bracket assembly removal (model X651)” on
page 549.
Does the problem remain?
Go to step 7. The problem is
solved.
7462
Diagnostic information
181
To Next Page
Loading...
