Lexmark 7462 series - Page 220

910.xx–917.xx error messages
Error code Description Action
910.00 The pick arm motor has stalled or become
obstructed.
Go to
“Pick arm motor service check” on
page 240.
911.00 The pick arm motor encoder continues to detect
pulse after motor stops.
912.00 The pick arm motor does not rotate at the specified
speed.
913.00 The pick arm motor does not rotate at the specified
speed.
914.00 The pick arm motor encoder detection is lost during
normal operation.
914.01 The pick arm motor does not rotate at the specified
speed.
915.00 The redrive motor encoder detection is lost during
normal operation.
Go to
“Redrive motor assembly service check”
on page 240.
915.01 The redrive motor does not rotate at the specified
speed.
916.00 The duplex drive motor encoder detection is lost
during normal operation.
Go to
“Internal duplex drive motor service
check” on page 241.
916.01 The duplex drive motor does not rotate at the
specified speed.
917.00 Problem with transfer — transfer servo start error. Go to
“Transfer problem service check” on
page 241.
920.xx error messages
Error code Description Action
920.00 Fuser does not maintain proper operating
temperature within steady state control.
Go to
“Fuser (920.00–920.04) failure service
check” on page 242.
920.01 The fuser hot roll took too long to heat up after
transitioning to new enhanced mode within
standby control only.
920.02 The fuser hot roll fell to far below desired
temperature while in standby control.
920.03 The fuser hot roll is too cool while checking for
slope change in standby.
920.04 The fuser hot roll is too cool when heating to
desired temperature after slope change within
standby control only.
920.06 The fuser hot roll temperature does not increase
while the lamp is turned on.
Go to
“Fuser (920.06) failure service check” on
page 243.
7462
Diagnostic information
220