214323 126 Revision A
Figure 3.178: Challenger Combine Display
4. Press HEADER button. The HEADER CALIBRATION
page displays a warning.
Figure 3.179: Challenger Combine Display
5. Read warning message, and then press green check
mark button.
Figure 3.180: Challenger Combine Display
6. Follow on-screen prompts to complete calibration.
NOTE:
The calibration procedure can be cancelled at any time
by pressing cancel button in bottom right corner of
page. While header calibration is running, calibration
can also be canceled by using up, down, tilt right, or tilt
left buttons on control handle.
NOTE:
If combine does not have header tilt installed or if it is
inoperable, you may receive warnings during
calibration. Press green check mark if these warnings
appear. This will not affect AHHC calibration.
OPERATION
To Next Page
Loading...
