214323 39 Revision A
3.3 Break-in Period
CAUTION
Before investigating an unusual sound or attempting to correct a problem, shut off engine and
remove key.
NOTE:
Until you become familiar with the sound and feel of your new header, be extra attentive.
After attaching the header to the combine for the first time, follow these steps:
1. Operate the machine with the reels, drapers, and knives running slowly for five minutes. Watch and listen
FROM THE OPERATOR’S SEAT for binding or interfering parts.
NOTE:
Reels and side drapers will not operate until oil flow fills the lines.
2. Refer to 5.3.2 Break-In Inspection, page 326 and perform all the specified tasks.
OPERATION
To Next Page
Loading...
