214323 329 Revision A
Service Intervals
Every 10 Hours
Use high temperature extreme pressure (EP2) performance with 1% max molybdenum disulphide (NLGI Grade 2)
lithium base unless otherwise specified.
Figure 5.4: Every 10 Hours or Daily
Knife: Lubricate the knife every 10 hours or daily, except in
sandy conditions.
Every 25 Hours
Use high temperature extreme pressure (EP2) performance with 1% max molybdenum disulphide (NLGI Grade 2)
lithium base unless otherwise specified.
Figure 5.5: Every 25 Hours
Knifehead: Lubricate the knifehead every 25 hours. Check
for signs of excessive heating on the first few guards after
greasing. If required, relieve the pressure by pressing the
check-ball in the grease fitting.
IMPORTANT:
To prevent binding and/or excessive wear caused by knife
pressure on the guards, do NOT overgrease the
knifehead (A). Apply only one to two pumps using a
mechanical grease gun (do NOT use an electric grease
gun). If more than six to eight pumps of the grease gun are
required to fill the cavity, replace the seal in the knifehead.
Refer to 5.8.3 Removing Knifehead Bearing, page 378.
MAINTENANCE AND SERVICING
To Next Page
Loading...
