214323 348 Revision A
5.5 Electrical System
Use electrical tape and wire clips as required to prevent wires from dragging or rubbing.
Keep lights clean and replace defective bulbs.
5.5.1 Replacing Light Bulbs
Figure 5.37: Clearance Light
1. Use a Phillips screwdriver to remove screws (A) from
the fixture and remove the plastic lens.
2. Replace the bulb and reinstall the plastic lens
and screws.
NOTE:
Use bulb trade #1156 for amber clearance lights and
#1157 for red tail light (Slow Speed Transport option).
MAINTENANCE AND SERVICING
To Next Page
Loading...
