MacDon FD75 - Adjusting Manual Header Raise;Lower Rate (John Deere S and T Series)

214323 187 Revision A
1003758
A
Figure 3.304: John Deere Combine Display
2. Press – or + icon (A) to adjust rates.
NOTE:
The numbers depicted on displays in these illustrations
are for reference purposes only; they are not intended
to represent specific settings for your equipment.
Adjusting Manual Header Raise/Lower Rate (John Deere S and T Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
combine operator’s manual for updates.
1003757
A
Figure 3.305: John Deere Combine
Command Center
1. Press button (A) and current sensitivity setting will
appear on monitor.
OPERATION