214323 7 Revision A
1.6 Safety Signs
Figure 1.14: Operator’s Manual Decal
• Keep safety signs clean and legible at all times.
• Replace safety signs that are missing or become illegible.
• If original parts on which a safety sign was installed are
replaced, be sure repair part also bears current
safety sign.
• Replacement safety signs are available from your Dealer
Parts Department.
1.6.1 Installing Safety Decals
1. Clean and dry installation area.
2. Decide on exact location before you remove decal backing paper.
3. Remove smaller portion of split backing paper.
4. Place sign in position and slowly peel back remaining paper, smoothing sign as it is applied.
5. Prick small air pockets with a pin and smooth out.
SAFETY
To Next Page
Loading...
