List of Revisions
At MacDon, we’re continuously making improvements, and occasionally these improvements affect product
documentation. The following list provides an account of major changes from the previous version of this
document.
Summary of Change Refer To
Added conventions used in this document. Introduction, page i
Updated illustrations of header and adapter serial plate
locations.
Model and Serial Number, page v
Updated header endsheet safety decal locations. 1.7 Safety Decal Locations, page 8
Added checking thread length to determine if
adjustment is required.
Checking and Adjusting Feed Auger Springs, page 49
Updated illustrations of wrench indicator. Checking Wing Balance, page 67
Added locations of reel fore-aft / header tilt toggle
switch for each combine manufacturer.
Controlling Header Angle, page 77
Added topic.
Setting Header Controls (Case 8010), page 113
Added image of voltage limits on combine display.
Checking Voltage Range from Combine Cab (Case IH
5130/6130/7130, 7010/8010; 7120/8120/9120; 7230/
8230/9230), page 114
Added header setup and calibration instructions for use
with John Deere S7 Series combines.
3.8.12 John Deere S7 Series Combines, page 191
Added Check Auger Drive Chain Tension and Check
Deck Height Adjustment.
5.3.2 Break-In Inspection, page 326
Corrected upper cross auger grease point descriptions. Every 250 Hours, page 333
• Updated service kit part number.
• Added instructions for replacing adapter fitting
MD #245160.
5.4.4 Changing Oil Filter, page 346
Updated illustrations to show line marked on bottom
cover.
5.7.2 Checking Auger Drive Chain Tension, page 357
Revised topic—No adjustment is required if spring
retainers are within +6 to –3 of flush and feed draper is
tracking properly.
5.10.2 Adjusting CA25 Feed Draper Tension, page 405
Added Second Stabilizer Wheel kit (B6179). 6.4.2 Stabilizer Wheels, page 484
Added Auger Dent Repair kit to Options and
Attachments.
6.5.7 Auger Dent Repair Kit, page 488
Updated U&A part numbers.
8.3 Unloading and Assembly, page 519
Removed single reel content throughout.
214323 iii Revision A
To Next Page
Loading...
