MacDon FD75 - Page 509

214323 491 Revision A
Symptom
Problem
Solution Refer to
Crop not being cut
at ends
Divider runs down thick
crop at ends, preventing
proper feeding due to
material bridging the
cutter guards
Replace three or four end
guards with stub guards
• 5.8.7 Knife Guards,
page 380
• 6.3.3 Stub Guard
Conversion Kit, page 482
• See your MacDon
Dealer
Material accumulating
in gap between cut-out
in endsheet and
knifehead
Crop heads leaning away
from knifehead hole in
endsheet
Add knifehead shield(s),
except in damp/sticky soils
5.8.8 Knifehead Shield,
page 391
TROUBLESHOOTING