MacDon M1240 - Filling Diesel Exhaust Fluid Tank

215916 117 Revision A
1022834
A
Figure 4.10: Engine Oil Dipstick Location
4. Locate the engine oil dipstick on the right side of the
windrower. Remove dipstick (A) by turning it
counterclockwise to unlock it.
5. Wipe the dipstick clean and reinsert it into the engine.
1000074
Figure 4.11: Engine Oil Level on Dipstick
6. Remove the dipstick again and check the oil level. The oil
level should be between the LOW (L) and HIGH (H) marks
on the dipstick. If the oil level is below the LOW mark, you
will need to add oil.
NOTE:
Adding 1.9 liters (2 U.S. quarts) of engine oil will raise the
level from LOW to HIGH. To add oil, refer to Adding Engine
Oil, page 117.
7. Replace the dipstick and turn it clockwise to lock it.
Adding Engine Oil
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator’s seat for any reason.
1. Open the hood. For instructions, refer to 5.3.1 Opening Hood, page 335.
2. Shut down the engine, and remove the key from the ignition.
OPERATION