EasyManua.ls Logo

MacDon M1240 - Narrow Transport System Troubleshooting

MacDon M1240
614 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
215916 392 Revision A
5.10 Every 250 Hours or Annually
Complete the following maintenance tasks every 250 hours of operation or annually, whichever occurs first:
Change engine oil and filter. For instructions, refer to 5.10.1 Changing Engine Oil, page 392.
Change engine primary air filter. For instructions, refer to 5.10.2 Maintaining Engine Air Filters, page 394.
Check wheel drive lubricant level. For instructions, refer to 5.10.3 Checking Wheel Drive Lubricant Level 10 Bolt, page
399.
Inspect exhaust system. For instructions, refer to 5.10.7 Inspecting Exhaust System, page 401.
Change engine gearbox oil. For instructions, refer to 5.10.8 Changing Engine Gearbox Lubricant, page 403.
5.10.1 Changing Engine Oil
The engine oil should be changed according to the interval specified in the windrowers Maintenance Schedule. The oil
filter should be changed whenever the engine oil is changed.
Draining Engine Oil
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operators seat for any reason.
NOTE:
The engine should be warm prior to changing the oil.
1. Shut down the engine, and remove the key from the ignition.
2. Place a drain pan with a capacity of about 24 liters (6 U.S. gallons) under the engine oil drain.
1012640
A
Figure 5.91: Engine Oil Drain Plug
3. Remove oil drain plug (A) and allow the oil to finish
draining.
4. Replace drain plug (A).
5. Check the condition of the used oil. If either of the
following is evident, have your Dealer correct the problem
before starting the engine:
Thin black oil indicates fuel dilution
Milky discoloration indicates coolant dilution
6. Dispose of the used oil in a manner that complies with local
rules and regulations.
Replacing Engine Oil Filter
NOTE:
Replace oil filter each time engine oil is changed.
1. Open the hood. For instructions, refer to 5.3.1 Opening Hood, page 335.
2. Place an oil pan below the filter.
MAINTENANCE AND SERVICING

Table of Contents

Other manuals for MacDon M1240

Related product manuals