MacDon M1240 - Removing Drive Wheels

215916 368 Revision A
1015828
A
B
C
D
Figure 5.50: Return Filter
NOTE:
The image shows the filter head removed for
component clarity.
7. Remove and discard gasket (C) from groove (B) in filter
head (A).
NOTE:
Filter (D) is shown to provide context.
Installing Return Oil Filter
The return oil filter removes particulate contaminants from the oil returning from the fan drive, lift circuits, and drive
circuits.
NOTE:
For filter specifications, refer to 5.1.5 Filter Part Numbers, page 329.
NOTE:
The image shows the filter head removed for component clarity.
1015828
A
B
C
D
Figure 5.51: Return Filter
1. Clean gasket groove (B) in filter head (A).
2. Apply a thin film of clean oil to new filter gasket (C).
IMPORTANT:
Do NOT pre-fill the filter before installation as this may
introduce unfiltered oil into the system.
3. Install new gasket (C) into groove (B) in filter head (A).
4. Screw new filter (D) onto the filter head until the gasket
just contacts the filter.
MAINTENANCE AND SERVICING