215916 137 Revision A
Figure 4.46: HPT Display
1. Press soft key 3 (A) on the Harvest Performance
Tracker (HPT) to open the PERFORMANCE DATA display.
NOTE:
Soft keys 1–5 also function as buttons within menus.
NOTE:
The sub acres can also be reset from this screen. Press the
HPT scroll knob to highlight and select the sub acres. If you
press the HPT scroll knob a second time, the message
RESET OR EXIT appears on the display. Select RESET to reset
the sub acres to zero and return to the same highlighted
sub acres. Select EXIT or press the BACK or HOME button to
dismiss the message without resetting the sub acres.
In this screen, you can view:
• Sub acres (A)
• Acres per hour (B)
• Fuel used per hour (C)
• Fuel used per acre (D)
4.3.7 Transporting
The windrower can be driven from one location to another. If correctly equipped, the windrower can also tow a header.
The windrower should generally NOT be towed, however, as this can result in damage to the hydrostatic drives, though a
procedure for emergency towing is provided.
Driving on Road in Engine-Forward Mode
The M1240 Windrower is designed to be driven on the road with the engine facing forward to provide better visibility for
the Operator and improved stability for the machine.
Windrowers sold in North America can also be driven on roads in cab-forward mode, with or without a header attached,
but at a reduced speed, under restricted conditions. For instructions, refer to Driving on Road in Cab-Forward Mode, page
140.
CAUTION
Windrowers sold outside of North America: Do NOT drive the windrower on the road in cab-forward mode, as the
lighting and marking will not be compliant with road regulations.
WARNING
A collision between the windrower and other vehicles may result in injury or death.
WARNING
When driving the windrower on public roadways:
• Obey all highway traffic regulations in your area. Arrange to have pilot vehicles in the front and the rear of the
windrower, if doing so is required by law.
• Display a slow-moving vehicle emblem and flashing warning lights, unless these actions are prohibited by law.
• If the width of the attached header impedes other vehicle traffic, remove the header and install a MacDon-
approved weight box on the windrower. This will allow the windrower to be driven safely on roadways without an
attached header.
OPERATION
To Next Page
Loading...
