215916 236 Revision A
Figure 4.283: Header Support
19. Install clevis pin (A) through the support and foot, and
secure it with hairpin (B). Repeat this step to install the
clevis pin on the opposite side of the header.
IMPORTANT:
Ensure that clevis pin (A) is fully inserted and that the
hairpin is installed behind the bracket.
Figure 4.284: Safety Prop Lever
20. Disengage the safety props on both lift cylinders as follows:
a. Turn lever (A) away from the header to raise the safety
prop until the lever locks into the vertical position.
b. Repeat the previous step for the opposite cylinder.
NOTE:
If the safety prop will NOT disengage, raise the header to
release the prop.
Figure 4.285: GSL
DANGER
Ensure that all bystanders have cleared the area.
21. Start the engine and press HEADER DOWN switch (A) on
the GSL to fully lower the header.
OPERATION
To Next Page
Loading...
