MacDon M1240 - Page 513

215916 493 Revision A
7.4 Header Drive Troubleshooting
Problem Solution
Section
Symptom: Header drive is not engaging.
OPERATOR PRESENCE switch not
closed or faulty
Occupy operator’s seat or replace
switch. Contact your Dealer.
Contact Dealer
OPERATOR PRESENCE switch not
closed or faulty
Occupy operator’s seat or replace
switch. Contact your Dealer.
Contact Dealer
Appropriate solenoid not being
energized by activating switch
Contact Dealer.
—
Couplers not connected
Contact Dealer.
—
Faulty pump or flow controls
Contact Dealer.
—
Control solenoids disconnected Contact Dealer.
—
Header ID not detected
Attach header or check wiring.
Contact your Dealer.
Contact Dealer
Symptom: Header drive lacks power.
Relief valve setting too low
Contact Dealer.
—
Header drive overload
Reduce ground speed.
—
Symptom: Warning alarm sounds.
Header drive overload
Reduce ground speed.
—
Relief valve setting too low
Contact Dealer.
—
TROUBLESHOOTING