ND-70348 (E) CHAPTER 4
Page 225
Revision 3.0
ASTD
Table 4-4 List for Assignment of ASTD (2/2)
STM STS
ST
*=standard settings
1
0
Trunk Release 0 Station (Calling Party Release)
1 Trunk
Note: Valid when C.O. line has a release
signal. (Standard setting is “1”.)
1
Sending ROT to the station upon receiving
CLR FWD signal (only for Russia)
0 Restricted
1 Allowed
2
3
4
* = standard settings
Note: One setting applies to five items. (STM=0, STS 0)
2
0
Three-way calling with COT included 0 Restricted
1* Allowed
1
Three-way calling with COT included in Exec-
utive Right of Way service
0 Restricted
1* Allowed
2
Outgoing call to a C.O. Line or a Tie Line after
holding the COT
0 Restricted
1* Allowed
3
Outgoing call to a C.O. Line after holding a
station or a Tie Line
0 Restricted
1* Allowed
4
Processing for calling a fully-restricted station
after holding the COT
0 Restricted
1* Allowed
Note: The call can be transferred.
5
Processing in which ATT overrides to the con-
nection between the COT and a station (Busy
Verification) and then the Busy Verification
Warning Tone is sent out periodically
0* Warning tone is sent out to both the station and
the ATT
1 Warning tone is sent out to the station, ATT,
and C.O. side.
6
Step call when a Tie Line incoming call en-
counters busy
0 Allowed
1 Restricted
40
Remote Access to PBX/Automated Attendant 0 Not provided
1* In service
6
0
Day/Night mode changeover system 0 Not used
1* Fixed to “1”.
10*
20*
30*
70
Not used 0
1
* = standard settings
To Next Page
Loading...
Need help?
General