ND-70348 (E) CHAPTER 4
Page 693
Revision 3.0
AEXFN
AEXFN: Assignment of EX-FCCS CCH Selection Data for NDM
1. General
This command is used to assign, delete and read out the Point Code data for connecting to each FPC in one
Fusion Group (FUG) within multiple FCCS networks connected via CCIS link.
2. Precautions
1. This command is not valid when the Self Fusion Group Number has not been allocated by the AFUGN
command.
2. Self Fusion Group Number cannot be entered in FUG parameter.
3. This command is available since Release 8 software enhancement.
3. Data Entry Instructions
FUSION GROUP
NUMBER
(FUG)
1-4
FUSION POINT
CODE
(FPC)
1-253
POINT CODE
(PC)
1-16383
REMARKS
FUG
Destination Fusion Group Number
connected to Self FUG.
FPC
Enter all the FPC in the destination
FUG connected to Self-FUG.
Assign all the Point Code in
destination FUG via CCIS network.
PC
To Next Page
Loading...
Need help?
General