ND-70348 (E) CHAPTER 4
Page 546
Revision 4.0
AISA
AISA: Assignment of Individual Speed Calling Entry Area
1. General
This command is used to designate the station type (MST or SLV) and the number of memory block to be used
for the Speed Calling Group/Station.
2. Precautions
1. One (1) Speed Calling - Station memory can be assigned a maximum of 18 digits for the long speed dial
number.
2. One (1) BLOCK consists of ten (10) Speed Calling - Station memories.
3. There are one hundred (100) BLOCKs per MG.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
5. The MST station user can register the speed dial number and also originate a speed dial call.
6. The SLV station user can originate a speed dial call, but speed dial number registration is not available.
The speed dial number registration is done by the MST station only.
7. The MST station and slave stations must be in the same MG.
8. The AISD command allows the maintenance person to register the speed dial number.
9. When assigning the individual speed calling entry block of the Attendant Console, use the Specific Atten-
dant Number previously assigned in the ASAT command.
10. To assign the individual speed calling entry area, consecutive vacant blocks are required for the number of
entry blocks. (If the block number is frequently modified/deleted, consecutive vacant block area would not
be obtained and assignment error may occur even if the block number has not exceeded 100.)
To Next Page
Loading...
Need help?
General