ND-70348 (E) CHAPTER 4
Page 72
Revision 3.0
ATIM
ATIM: Assignment of Date and Time
1. General
This command is used to set the clock information of the system. Clock information is executed when Y is
entered in WRT? field and the Enter key pressed.
2. Precautions
1. The clock is assigned in military time.
2. Clock information assigned in this command is necessary for the following purposes:
(a) To indicate time for D
term
and ATT (Desk Console/Hotel Console)
(b) To specify the time for changing the route pattern for LCR
(c) To specify the time and date for changing the number development for LCR
(d) To specify the time for outgoing calls or for refusing incoming calls
(e) To specify the start time for the routing diagnosis
(f) To specify a length of time for Traffic Measurement
(g) SMDR
3. The system automatically takes the leap year into account.
To Next Page
Loading...
