ND-70348 (E) CHAPTER 4
Page 258
Revision 3.0
ATCP
ATCP: Assignment of Time/Pattern Change Information Data
1. General
This command is used to assign the time period corresponding to each Time of Day Change Pattern Number
(TDPTN). These Time of Day Change Patterns are used to change the routes to be used during a specific time
period, so that trunks can be used effectively and call charges can be kept to a minimum.
2. Precautions
1. The data assigned by this command is required for the ACBC/AOPR/ASDC commands. However, when
the Clocked Manual Override data is assigned by the ACMO command (used for changing routes during
a specific time period), the ACMO data has priority over data assigned by the ATCP command to the
ACBC/AOPR/ASDC commands.
2. Assignment intervals must be at least 30 minutes.
3. If the time data is assigned in duplicate, the latter assignment shall take effect. For example,
“9:00~12:00=TDPTN1” is set then “11:00~15:00=TDPTN2” is specified, the time setting
“9:00~11:00=TDPTN1” / “11:00~15:00=TDPTN” is to be executed.
3. Data Entry Instructions
Note: “TDPTN=0” is used in default setting (in unspecified time period). Thus the assignment “TDPTN=0”
means nothing in this command.
The time period TDPTN is
effective.
09
20
00:
00
TIME DATA FOR TDPTN
TIME DATA FOR TDPTN
:
:
:
20
09
00:
00
:
:
(FROM) (TO)
HOUR MINUTE HOUR MINUTE
TIME OF DAY
CHANGE
PATTERN
(TDPTN)
0-7
REMARKS
0
1
2
3
Enter the pattern number corresponding to TDPTN
assigned at AOPR/AOPRL/ASDC commands. Note
TDPTN
To Next Page
Loading...
Need help?
General