NEC NEAX 7400 IMX - ADA2: Assignment of DTE Attribute Data 2

ND-70348 (E) CHAPTER 4
Page 383
Revision 3.0
ADA2
ADA2: Assignment of DTE Attribute Data 2
1. General
This command is used to assign the Attribute Data for the data communication service feature of the data adapter
(DA) with the D
term
and/or the data module (DM).
2. Precautions
1. When the designated station is not a DTE (DA/DM), the Attribute Data cannot be assigned and an error
code will result.
3. Data Entry Instructions
See Data Sheet on the next page.