ND-70348 (E) CHAPTER 4
Page 386
Revision 3.0
ADA2_T
ADA2_T: Assignment of DTE Attribute Data 2 – Telephone Number
1. General
This command is used to assign the Attribute Data for the data communication service feature of the data adapter
(DA) with the D
term
and/or the data module (DM). The station data of ADA2 command can be assigned by using
Telephone Number instead.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network can be written.
3. When the designated station is not a DTE (DA/DM), the Attribute Data cannot be assigned and error code
will result.
4. This command is available since Release 8 software enhancement.
3. Data Entry Instruction
See data sheet on the next pages.
To Next Page
Loading...
Need help?
General