ND-70348 (E) CHAPTER 4
Page 538
Revision 3.0
AUADN
AUADN: Assignment of UCD Delayed Announcement Data for NDM
1. General
This command is used to assign the data related to the Delay Announcement - UCD for Netfusing Service. The
data assigned by this command is written in the Network Data Memory (NDM) of the Network Control Node
(NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. Assign the Telephone Number (NDM) of the UCD member station by using the ASHUN command.
2. A maximum of eight (8) external announcement machines can be assigned per a UCD group.
3. As to the designation of sharing the UCD Announcement Information (ASYDL, SYS1, INDEX804, bit4:
0/1 = per UCD group/Common), be sure to follow the notes as mentioned below;
• Common in all the UCD groups (b4 = 1 is assigned) means the UCD Announcement Information is
common in each Node.
• In case the system data (ASYDL, SYS1, INDEX804, bit4) shall be modified after the UCD Announce-
ment Information has already been assigned, first clear all the data assigned by this command
(AUADN), then the new data is to be reassigned.
To Next Page
Loading...
Need help?
General